I'm having an issue that I can't currently figure out. In my application I have
two wireless access points that I've connected to previously. I've looked in
their settings file, and they have the proper passwords in them. I'm currently
attached to AP 1. I disconnect it, then attempt to connect to AP 2. I receive back to my
registered agent a connection error, and the error that the service reports is
Input/Output error. This is typically what I see when I enter a bad password when I first
connect to the AP. So, I remove the service and try to connect to the original AP and I
get the same Input/Output error on the AP that I was previously connected to. I've
been trying to figure this out for days, but have not yet followed why this is happening.
I've turned on debugging, and attached that log. If you could kindly help me to
understand what's going on, I would appreciate it.
Show replies by date