Greetings, I am trying to prioritize Ethernet over WiFi connectivity using connman on an embedded Linux device. If no Ethernet cable is plugged in connman attempts to connect with WiFi. However, if an Ethernet cable is plugged in to a link-local network with no internet access connman does not fall back to WiFi. I read some documentation that lead me to believe that it would. "Services of the listed technology type will be tried one by one in the order given, until one of them gets connected or they are all tried. A service of a preferred technology type in state 'ready' will get the default route when compared to another preferred type further down the list with state 'ready' or with a non-preferred type; a service of a preferred technology type in state 'online' will get the default route when compared to either a non-preferred type or a preferred type further down in the list." I consider a link-local IP address to be 'ready' not 'online' so why does connman stay connected to Ethernet in this case? I have the following lines in my device's /etc/connman/main.conf. PreferredTechnologies = ethernet,wifi,cellular SingleConnectedTechnology = true Cheers, Frank