Yes, I replaced my file system name with <fsname> in the email.
-Konstantin
From: Patrick Farrell [mailto:paf@cray.com]
Sent: Friday, October 17, 2014 1:35 PM
To: Konstantin Litovskiy; hpdd-discuss@lists.01.org
Subject: Re: [HPDD-discuss] Can't Mount MDT on MDS/MGS server
Konstantin,
A quick thought: Did you deliberately remove your file system name and replace it with <fsname> in your email? Otherwise, you probably want to change the file system name in the format command
and try again. I’ think the ‘<‘ and ‘>’ symbols may cause problems. (If not now, they probably will for some other software at some point.)
- Patrick Farrell
From: Konstantin Litovskiy <konstantin@baymicrosystems.com>
Date: Friday, October 17, 2014 at 3:28 PM
To: "hpdd-discuss@lists.01.org" <hpdd-discuss@lists.01.org>
Subject: [HPDD-discuss] Can't Mount MDT on MDS/MGS server
Hello, I am new to Lustre and am trying to setup a simple environment (1 of each Client, MDS, OSS) to test basic functionality and to familiarize myself with the installation procedures.
I currently have 3 VM’s each running CentOS 6.5. I have 3 nic in each box, with eth0 being used for ssh and eth1 and 2 being teamed under bond0. I want all LNET communication going through the bond0 interface.
My lustre.conf:
# cat /etc/modprobe.d/lustre.conf)
options lnet networks=tcp0(bond0)
I have disabled iptables, selinux, etc. I can load and start lnet. I can ping each machine’s bonded interface using normal ping so I know the networking is fine. Right now the MDS is the only server on.
# lctl ping
100.100.100.10@tcp0
12345-0@lo
When I try to mount the MDT, I get this error:
# mount –t lustre /dev/sdb /mnt/mdt
LustreError: 11-0: <fsname>-MDT0000-lwp-MDT0000: Communicating with 0@lo, operation mds_connect failed with -11
Any help would be appreciated.
Thank You,
-Konstantin