Hi, I tried to switch from wpa_supplicant to iwd to start an access point. When looking at the scan results from another machine, I see that when using iwd, the device sends no HT capabilities and only supports 11MBit/s. output from "iw dev wlp2s0 scan": with iwd based ap: ----- BSS 74:da:38:f4:e1:42(on wlp2s0) last seen: 789976.536s [boottime] TSF: 11382336 usec (0d, 00:00:11) freq: 2437 beacon interval: 100 TUs capability: ESS Privacy (0x0011) signal: -48.00 dBm last seen: 4088 ms ago Information elements from Probe Response frame: SSID: testbox Supported rates: 1.0* 5.5 11.0 DS Parameter set: channel 6 RSN: * Version: 1 * Group cipher: CCMP * Pairwise ciphers: CCMP * Authentication suites: PSK * Capabilities: 1-PTKSA-RC 1-GTKSA-RC (0x0000) WPS: * Version: 1.0 * Wi-Fi Protected Setup State: 2 (Configured) * Response Type: 3 (AP) * UUID: 927467be-c802-5217-a136-a5489eb14b24 * Manufacturer: * Model: * Model Number: * Serial Number: * Primary Device Type: 1-00372a04-1 * Device name: testbox * Config methods: PBC * Unknown TLV (0x1049, 6 bytes): 00 37 2a 00 01 20 ----- with wpa_supplicant based ap: ----- BSS d0:37:45:99:3e:1f(on wlp2s0) last seen: 789193.105s [boottime] TSF: 5592759 usec (0d, 00:00:05) freq: 2412 beacon interval: 100 TUs capability: ESS Privacy ShortSlotTime (0x0411) signal: -58.00 dBm last seen: 3230 ms ago Information elements from Probe Response frame: SSID: testbox Supported rates: 1.0* 2.0* 5.5* 11.0* 6.0 9.0 12.0 18.0 DS Parameter set: channel 1 ERP: Barker_Preamble_Mode Extended supported rates: 24.0 36.0 48.0 54.0 RSN: * Version: 1 * Group cipher: CCMP * Pairwise ciphers: CCMP * Authentication suites: PSK PSK/SHA-256 * Capabilities: 16-PTKSA-RC 1-GTKSA-RC (0x000c) HT capabilities: Capabilities: 0x92c HT20 SM Power Save disabled RX HT20 SGI RX STBC 1-stream Max AMSDU length: 7935 bytes No DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 16 usec (0x07) HT Max RX data rate: 476 Mbps HT TX/RX MCS rate indexes supported: 0-7 HT operation: * primary channel: 1 * secondary channel offset: no secondary * STA channel width: 20 MHz * RIFS: 0 * HT protection: no * non-GF present: 0 * OBSS non-GF present: 0 * dual beacon: 0 * dual CTS protection: 0 * STBC beacon: 0 * L-SIG TXOP Prot: 0 * PCO active: 0 * PCO phase: 0 WMM: * Parameter version 1 * u-APSD * BE: CW 15-1023, AIFSN 3 * BK: CW 15-1023, AIFSN 7 * VI: CW 7-15, AIFSN 2, TXOP 2976 usec * VO: CW 3-7, AIFSN 2, TXOP 1472 usec WPS: * Version: 1.0 * Wi-Fi Protected Setup State: 2 (Configured) * Unknown TLV (0x1049, 6 bytes): 00 37 2a 00 01 20 * Device name: * Primary Device Type: 0-00000000-0 ----- Is this a driver issue or a general problem with iwd? Best regards, Georg