On 02/17/2017 09:06 AM, Christophe Ronco wrote:
Command read_file_info on MC7304 always fails.
Using qmicli or AT command, I am able to read file info.
Qmicli command is:
qmicli -d /dev/cdc-wdm0 --uim-get-file-attributes=0x3f00,0x7fff,0x6fad
[(null)] Successfully got file '/dev/cdc-wdm0' attributes from the UIM:
File size: 4
File ID: 28589
File type: transparent
Record size: 0
Record count: 0
Read security attributes: (always) (null)
Write security attributes: (single) adm
Increase security attributes: (always) (null)
Deactivate security attributes: (single) adm
Activate security attributes: (single) adm
After a check of parameters sent by qmimodem driver and qmicli,
the only difference is on parameter "Session Information".
Session type sent by qmimodem driver is 'Card on slot 1'.
Session type sent by qmicli command is 'primary-gw-provisioning'.
Changing session type in qmimodem driver fixed problem (on this modem).
Comparing with what is done by qmili command
drivers/qmimodem/sim.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)