[SyncEvolution] SSL support, Syncevolution as HTTP server?
by Anssi Saari
The Syncevolution HTTP server setup docs say somewhat cryptically that
"HTTPS is probably possible by extending the way how Twisted is used
and/or configured." So what actually needs to be done? Has anyone done
any work relating to this? I'm currently using a Nexus One with
Synthesis which says it supports SSL, so I should have the client end
covered.
10 years, 5 months
[SyncEvolution] Problem after upgrade
by Gordon Dickens
Hello,
I just upgraded to Ubuntu 10.10 and to SyncEvolution 1.1 and I am
running into a problem.
As an FYI, I have been running SyncEvolution successfully for the past
couple of years starting with Ubuntu 8.04 without any problems.
I don't know if it was the Ubuntu upgrade or the SyncEvolution upgrade
that is causing the problem. I have a syncevolution server configuration
named "funambol" which is located at: ~/.config/syncevolution/funambol.
When I attempt to sync using the command "syncevolution funambol" then
I get the following error message:
[ERROR] No configuration for server "funambol" found.
[ERROR] cannot proceed without configuration
Also, when I run the command "syncevolution --print-servers" then my
funambol server is not listed.
However, I do indeed have the same funambol server configured that I
have always had at:~/.config/syncevolution/funambol.
I subsequently noticed that a new empty directory had appeared in my
funambol server's directory named "peers" at
~/.config/syncevolution/funambol/peers. I found that if I delete the
"peers" directory then syncevolution finds my funambol server and
"syncevolution funambol" runs perfectly except it subsequently creates
the "peers" directory again each time that I run "syncevolution
funambol" so it will not run successfully thereafter without deleting
the "peers" directory again and again. Weird...
So, my configuration works so long as I delete the "peers" directory
prior to running "syncevolution funambol". However, this shouldn't be
necessary. Please reply with any insight as to how I can get my
installation back running properly again.
Thanks,
Gordon Dickens
10 years, 5 months