[edk2] [PATCH edk2-platforms 2/2] Platform/ARM/Sgi: Use NT_FW_CONFIG instead of HW_CONFIG

Thomas Abraham thomas.abraham at arm.com
Thu Dec 6 10:01:21 PST 2018


On Thu, Dec 6, 2018 at 10:25 PM Ard Biesheuvel
<ard.biesheuvel at linaro.org> wrote:
>
> On Thu, 6 Dec 2018 at 16:50, Thomas Abraham <thomas.abraham at arm.com> wrote:
> >
> > Hi Ard, Leif,
> >
> > On Tue, Dec 4, 2018 at 5:31 PM Chandni Cherukuri
> > <chandni.cherukuri at arm.com> wrote:
> > >
> > > The hardware configuration in HW_CONFIG dts is not being
> > > passed onto the operating system but used and terminated
> > > at edk2 boot stage (BL33). So, as per the recommendations
> > > of the trusted-firmware design, the hardware description
> > > specified in NT_FW_CONFIG dts should be used instead of
> > > HW_CONFIG dts.
> >
> > The corresponding change in upstream trusted firmware has been merged.
> > So can you please have a look at this patch and let us know if any
> > changes are needed. Until this patch gets merged, the upstream master
> > branch of trusted firmware and edk2-platforms support for SGI
> > platforms is out of sync with each other. We will take care next time
> > to avoid causing dependencies like these between these two repos.
> >
>
> For the series
>
> Reviewed-by: Ard Biesheuvel <ard.biesheuvel at linaro.org>
>
> Pushed as 07c6bc27730d..327ff4ae71ae

Thank you Ard.


More information about the edk2-devel mailing list